Short answer: Every pool runs on the same core equipment: a pump that moves the water, a filter that cleans it, and a sanitizer system that keeps it safe. For a new pool in North Texas, federal efficiency rules mean the main filter pump will almost always be a variable-speed pump. The bigger choices are the filter type (cartridge, sand or DE), whether to use a salt chlorine generator, and how much automation, heating and lighting you want. The right mix depends on your pool’s size, the trees around it, and how much hands-on care you want to do.
What equipment does a new pool need?
- Pump: circulates water through the filter, sanitizer and heater, and powers features like spillover spas and water features.
- Filter: removes dirt, pollen and debris. The three main types are cartridge, sand and diatomaceous earth (DE).
- Sanitizer: keeps the water safe, either with a salt chlorine generator or with chlorine added directly.
- Automation: controls the pump schedule, lights, heater and features from a panel or phone app.
- Optional: a heater or heat pump, a robotic or in-floor cleaner, and LED pool and landscape lighting.
These pieces sit together on an equipment pad, so they should be planned with the pool layout, not added at the end. Where the pad goes affects noise near bedrooms and patios, plumbing runs, and drainage.
Do new pools have to use a variable-speed pump?
In practice, yes for the main filter pump. Under U.S. Department of Energy rules that took effect July 19, 2021, most inground pool filter pumps must meet efficiency standards that single-speed pumps generally cannot reach. A later DOE rule on pool pump motors goes further: under federal regulations, pool pump motors from 1.15 to 5 total horsepower made on or after September 29, 2025 must have variable-speed control, and smaller motors from 0.5 up to 1.15 horsepower have a September 28, 2027 compliance date. In April 2026 DOE announced enforcement relief for some of those smaller motors. These are federal rules, so they apply in Texas just as they do everywhere else.
Variable-speed pumps are worth it on their own. A pump uses far less power at low speed, roughly one-eighth the power at half speed, so a variable-speed pump can run longer and quieter at a low setting for daily filtering, then ramp up only when a spa, water feature or cleaner needs more flow. In a North Texas summer, when pools need long daily run times, that difference adds up.
Cartridge, sand or DE: which pool filter is best?
| Filter type | How it works | Upkeep | Good fit for |
|---|---|---|---|
| Cartridge | Pleated fabric cartridges trap debris | Remove and hose off the cartridges; no backwashing | Most residential pools, and owners who want to save water |
| Sand | Water passes through a bed of filter sand | Backwash when pressure rises; the simplest to run | Owners who want low-effort cleaning and don’t mind backwash water |
| DE (diatomaceous earth) | A fine powder coats internal grids | Backwash and recharge with new DE powder | Owners who want the finest filtration |
Pools under heavy trees, which are common in established parts of Richardson, Dallas, Highland Park and University Park, collect more leaves and pollen, so filter size and a good skimmer and cleaner setup matter as much as filter type.
Where does pool backwash water go?
Backwash water from sand and DE filters carries dirt, filter media and pool chemicals, so many cities do not allow it in the street or storm drain. In Richardson, for example, the City of Richardson’s pool drainage guidance says its code prohibits draining filter backwash into the storm drain system or any watercourse. The city suggests using backwash water to irrigate your landscaping where possible, keeping it out of streets and alleys, and using the home’s sewer clean-out when draining large amounts of pool water. Rules differ from city to city, so we check them for each project. Cartridge filters avoid backwashing altogether, which is one reason they are popular here.
Is a saltwater pool worth it in North Texas?
A saltwater pool is still a chlorine pool. A salt chlorine generator uses electricity to turn dissolved salt into chlorine inside a cell on the equipment pad. The salt level is low, typically about 2,700 to 3,400 parts per million for many residential systems, depending on the manufacturer. Owners like that the water feels softer and that they handle and store less chlorine.
Things to know before choosing salt:
- It still needs testing. Free chlorine, pH and stabilizer still have to be balanced, and salt systems tend to push pH up.
- The cell wears out. Salt cells commonly last about 3 to 7 years, depending on run hours, salt level, scale and cleaning.
- Materials matter. Salt water can be hard on some natural stone, so we choose coping, decking and wall materials with salt in mind and seal them where needed.
- Plants matter too. Salty splash-out and drain water can harm salt-sensitive plants, so we plan the landscaping around the pool accordingly.
What about heaters, automation and lighting?
Heating: Heat pumps work well for extending the swim season in spring and fall, while gas heaters heat a spa quickly. Many pools with an attached spa use a gas heater for that reason. Automation: A control system lets you set pump schedules by season, turn on the spa from your phone, and run lights and water features without walking to the equipment pad. Lighting: LED pool lights tied into the same system as your outdoor living and landscape lighting make the whole backyard easy to use at night.
How do you choose the right equipment for your pool?
- How big is the pool, and will it have a spa, spillover or water features that need extra flow?
- How many trees are near the water?
- Do you want to clean cartridges a few times a year, or backwash more often?
- Would you rather manage chlorine by hand or let a salt system make it?
- Do you want to swim in spring and fall, or only in summer?
- Where can the equipment pad go so it is quiet, accessible and well drained on North Texas clay?
How does Four Seasons plan pool equipment?
Four Seasons Lawn + Landscaping designs the pool, equipment pad, decking, outdoor living spaces, lighting, drainage and landscaping as one plan, so the equipment is sized for the pool you are actually building. Four Seasons custom pools start at $120,000, because we don’t take shortcuts and we build pools that last. Licensed and insured, we have been building outdoor spaces in North Texas since 2001.
See our custom pool services and pool pages for Plano, Frisco, Allen and Dallas. Our office is in Murphy, minutes from Richardson, Plano, Wylie and Sachse. Still planning? Read how long a pool takes to build in DFW, gunite vs. shotcrete vs. fiberglass, or our DFW pool cost guide.
Frequently asked questions
Do I need a variable-speed pool pump in Texas?
For the main filter pump on a new inground pool, almost certainly. Federal DOE efficiency rules that took effect in 2021 are met in practice only by variable-speed pumps for most inground filter pumps, and since September 29, 2025, pool pump motors from 1.15 to 5 total horsepower must have variable-speed control. These federal rules apply in Texas.
Which pool filter is best: cartridge, sand or DE?
All three work well when sized correctly. Cartridge filters need no backwashing and save water, sand filters are the simplest to run, and DE filters give the finest filtration but need backwashing and new DE powder. The best choice depends on pool size, nearby trees and how you want to maintain it.
Is a saltwater pool chlorine-free?
No. A salt chlorine generator turns dissolved salt into chlorine. The water feels softer and you handle less chlorine, but you still test and balance free chlorine, pH and stabilizer.
How long does a pool salt cell last?
Salt cells commonly last about 3 to 7 years. Run hours, salt level, calcium scale and how often the cell is acid-cleaned all affect its life.
Can I drain pool backwash water into the street in Richardson?
No. City of Richardson guidance says its code prohibits draining filter backwash into the storm drain system or any watercourse. The city suggests using backwash water to irrigate landscaping where possible and using the home’s sewer clean-out when draining large amounts of pool water.
How much does a Four Seasons custom pool cost?
Four Seasons custom pools start at $120,000. The final price depends on your yard, the size and features of the pool, and how much decking, outdoor living and landscaping is included.
Plan your pool and equipment together
The best equipment choices come from looking at your yard, your trees and how you want to use the pool. A designer can walk your property and plan the pool, equipment and landscaping as one project. Call (214) 504-4250 or request a design consultation. Financing is available for qualified homeowners.
(214) 504-4250